Saradhi engineering is eminent Industrial Rubber bearings Manufacturers in Hyderabad. Rubber Bearing which consists of alternative laminations of thin rubber layers and steel plates bonded together to provide vertical rigidity and horizontal flexibility.Our products are manufactured by using high grade steel and synthetic rubber. These bearings guarantee maximum bearing capacity. These bearings are manufactured to accommodate vertical, longitudinal, horizontal,transverse which are caused by thermal effect, traffic loads, structural load, wind load and much more.Rubber bearings successfully release the stress on the bridge and have excellent rotation in all the directions and movements. Rubber Bearings can be availed in several dimensions and customized options.Our rubber bearings which is supplied are used on various vessels such as cargo boats, ferry boats, tug boats, pusher boats.Our bearings with quality rubber do not damage the shaft sleeve and offer smooth rotation of the shaft over a long period of time.
SARADHI COMPRESSION SEAL EXPANSION JOINT consists of steel armoured nosing at two edges of the joint gap suitably anchored to the deck concrete and a performed chloroprene elastomer compressed and fixed into the joint gap with special adhesive girder.
The compression seal will cater for a horizontal movement upto 40mm and vertical movement of 3mm.
It is recommended for simply supported or continuous spans right or skew moderately curved with maximum horizontal movement not exceeding 40mm.
SARADHI SLAB SEAL joint will consist of steel insert and elastomeric slab unit. This type of seal is recommended for simply supported or continuous spans, right or skew (less than 20 degree), moderately curved with maximum movement upto 50mm.
SARADHI SLAB SEAL expansion joint has been used for many years with a good success rate. However, the larger size of the joint tends to create more noise under traffic.
SARADHI Elastomeric joints are normally supplied in unit length and fixed to the deck using bolt anchors. If required tensioned cast iron bolts should be used to anchor this joint. If site drilled installations are used, the holes should be under reamed prior to fixing the bolts. An adequate length of the bolt should be de-bonded so that any relaxation over the bolt length does not result in complete loss of tension in the bolt.
It provides unique properties to withstand high water pressure in combination with large movements in all directions.
It is an ideal solution for joints where large gap movements are expected as a result of temperature effects and/or settlement Omega profile can be manufactured in a variety of sizes to fit almost any application. It is ideal for Metro rail projects
